Return to Aerosoft A319/A320/A321

Earlier this week I made the decision to return back to using the Aerosoft Airbus versions of the A319, A320 and A321 and thus (for now) grounding my FSLabs A319 and A320.  While I truly believe the FSLabs versions of the popular Airbus aircraft are certainly more immersive and also more study-level, I’ve been battling some issues with the FSLabs which I’ve not be able to fully address. 

Since COVID-19 has me working from home since mid March, I’ve been using the time to enjoy flight sim.  No, I’m not constantly flying all day when I should be working.  But I do generally start up a 3-4 hour flight in the morning and time it to land during my lunch break.  I will often depart for a second flight during lunch and time that to land just after my day has finished.  Alternatively, I’ve loaded up a long-haul with a duration of 9-10 hours in the same fashion.  During the in-flight time my capable first officer (auto pilot) is flying the aircraft.  I’ve been doing this on an almost daily basis since the beginning of the quarantine and as a result have racked up a few hundred hours of flight time this way. 

2020-5-22_7-15-29-865

Aerosoft A321 American Airlines

When flying any of my PMDG aircraft (B738, B777 or B744) or the QualityWings B788 the autopilot just quietly controls the aircraft and there are no issues.  However, when wanting to fly either of my FSLabs Airbus aircraft, the same can’t be said.  Almost every time I fly the FSLabs aircraft I will experience constant auto pilot disconnects.  These disconnects (unless I’m paying attention) usually end in with my aircraft doing a nose dive into the ground or water below. 

The FSLabs forums do offer pointers on how to control this behavior.  The main cause for this is turbulence and I’ve adjusted ActiveSky exactly how the info on the forums suggest.  So much so there’s almost very little observed turbulence, yet the AP continues to disconnect.     Short of flying without Activesky, I’m just not sure how else to try to resolve this issue.  In reading the forums, I’m not the only one that (even when following the recommended settings) continue to experience this behavior on almost every flight. 

Most say, this is just the behavior of the Airbus.  I’m not a real world pilot and I don’t personally know anyone that is.  But none of my Boeing aircraft (and the PMDG aircraft I own are just as study level as the FSLabs) behave in this way.  So what I come away with is the tolerances within the FSLabs are just too restrictive as compared to what I’m used to. 

So having said all this, I’ve returned to using the Aerosoft versions of the Airbus.  In doing so, I’m quite surprised at just how much this aircraft has matured.  The last time I seriously used the Aerosoft versions I was on P3Dv3.  At that time they were pretty basic, certainly so when I compared them with the FSLabs.  I still prefer my PMDG Boeing aircraft and I’m also enjoying the QW Dreamliner. But from time to time I do enjoy flying the Airbus series and for my Monday – Friday flights, the Aerosoft will work just fine.  I may even pickup their A330 soon.

Until next time…

Happy Flying!

Jerry


Leave a Reply

Your email address will not be published / Required fields are marked *

GrizzlyBearSims

10 User(s) Online Join Server
  • MEE6
  • Craig
  • MonitoRSS
  • PistolpackerWV
  • GrizzlyBearSims
  • 𝓓𝓾𝓬𝓴𝔃𝓸𝓻𝓵𝔂 🦆
  • Gabrielius
  • Dovsiljul
  • FarmerBernie
  • Aeppel